32
TRANSMISSION GEARBOX (A).
Models EN-9F3B / EN-12B and EN-12F4.
Lubrication: The first time the machine is operated, add 1
liter of oil.
First change the oil after 50 hours of operation. The next
changes are after 300 hours of operation.
Lubricant: 150/CLP Oil.
Remove the existing screw on the bottom of the
transmission gearbox to drain the oil.
Fill the oil periodically as necessary.
TRANSMISSION GEARBOX (B).
Models EN-6400 / EN-6500 / EN-6600 / EN-6700F4 and
EN-6800.
Lubrication: The first time the machine is operated, add 1
liter of oil.
First change the oil after 50 hours of operation. The next
changes are after 300 hours of operation.
Lubricant: 150/CLP Oil.
Oil carter capacity: 800 ml.
Remove the existing screw on the bottom of the
transmission gearbox to drain the oil.
Fill the oil periodically as necessary.
T R A N S M I S S I O N G E A R B O X F O R T R A C TO R
ACCESSORIES.
First change the oil after 50 hours of operation. The next
changes are after 300 hours of operation.
Recommended lubricant: 150/CLP Oil.
Oil carter capacity: 800 ml.
Fill the oil periodically to the appropriate level.
Conservation
Keep the machine clean and lubricated.
Periodically check the belts, blades, counter-blades, springs, and screws.
We recommend performing an annual over-all tune-up on the Ensiling Machine identifying and
replacing the worn or damaged parts.
Perform before extended stoppages:
- Carefully wash the machine with water;
- Retouch the paint in any parts whenever needed;
- Apply anti corrosive oil on metallic parts;
- Loosen the belts and release the pick-up roller springs;
- Clean the grease fitting and lubricate;
- Lubricate the bearings, unloader nozzle-chute etc.
fig.71
fig.72
Instruction manual
