11
Computer and pen communication
1
Insert the plug and play USB receiver into a free USB port on the computer.
The USB receiver status light will flash red, blue then green. The Nobo
Kapture™ software installer will automatically start. If it does not auto-run, start
the application manually by navigating to it via Windows explorer or Mac OS
finder.
The LED light will be red until the software is launched, upon which it will turn
blue.
Follow the on-screen instructions to install the Nobo Kapture™ software.
Confirm there is a battery installed in the pen.
2
Start up the installed Nobo Kapture™ software (
) and select capture
mode (
) followed by pen management mode (
).
Touch the pen (with or without the cap) to the middle of the setup card, hold
it there until the LED turns solid green.
Press and release the button on the USB receiver.
Lift the pen, the light will flash green, it will return to solid green when paired
to the system.
3
The pen will appear in the pen status area of pen management mode.
The pen is now paired to the system.
Set the pen colour
4
Touch the pen to the colour area on the setup card that matches the colour of
the installed ink cartridge. The colour shown in the pen management mode/
colour area will change to the selected colour. The pen is now ready to use.
Note:
Once the pen is paired it will remain paired to that USB receiver. Pens can be deleted
through the software. Additional pens must be paired in the same way as the first.
Pairing is unaffected by loss of power or changing the pens battery.
The USB receiver must remain in the USB port while capturing.
Setup / initial system setup
1
2
3
4
