OPERATION
UltraShine Burnisher (06--03)
13
TRANSPORTING MACHINE
1. Unplug the power cord and remove the pad from
the machine. Neatly coil the cord around the cord
hook and handle to prevent cord damage.
2. Load the machine using a recommended loading
ramp or carefully lift the machine with adequate
assistance.
FOR SAFETY: When transporting machine, get
assistance when lifting machine.
3. Secure machine with tie--down straps when
transporting by vehicle.
WARNING: Do Not Use Outdoors. Do Not
Expose to Rain. Store Indoors.
RECOMMENDED STOCK ITEMS
Refer to the Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description as shown (Figure 10).
FIG. 10
TROUBLE SHOOTING
PROBLEM
CAUSE
SOLUTION
Machine does not operate.
Machine is unplugged.
Plug machine in.
The cord connection between the
handle and the base is not properly
connected.
Ensure proper cord connection.
Machine circuit breaker tripped.
Reset the circuit breaker on machine.
Building circuit breaker tripped.
Reset circuit breaker in building.
Faulty power cord.
Contact Service Center.
Faulty wiring.
Contact Service Center.
Faulty On/Off Lever Switch.
Contact Service Center.
Faulty rectifier.
Contact Service Center.
Machine circuit breaker trips
continuously.
Excessive pad pressure.
Adjust pad pressure knob.
Heavily soiled pad.
Replace Pad.
Improper pad for application.
Change to proper pad.
Faulty circuit breaker.
Contact Service Center.
Worn carbon brushes in motor.
Contact Service Center.
