Nobles Speed Scrub Orbital, Руководство по эксплуатации, Страница: 7 / 86

OPERATION
Nobles Speed Scrub Orbital (12--2012)
7
MACHINE INSTALLATION
UNCRATING MACHINE
1. Carefully check the shipping crate for signs of
damage. Report damages at once to carrier.
2. Check the contents list. Contact distributor for
missing items.
Contents:
D
2--12 V Batteries -- Optional
D
24V Battery Charger -- Optional
D
3--Foam Battery Spacers (#630375)
D
Battery Tray (#1012994)
D
15 in / 38 cm Battery Cable (#130364)
D
4--Battery Cable Rubber Boots
D
Squeegee Assembly (#9001178)
3. To uncrate your machine, remove the shipping
hardware and straps that secure the machine to
the pallet. With assistance, carefully lift the
machine off the pallet.
ATTENTION: Do not roll machine off pallet unless a
ramp is used, machine damage may occur.
ATTENTION: To prevent possible machine damage,
install batteries after removing machine from
shipping pallet.
INSTALLING BATTERIES
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Hood Open When
Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Recommended Battery Specifications:
Two 12 volt deep cycle lead acid batteries.
155 AH battery -- 20 in / 50cm
Maximum battery dimensions: 6.85 in / 174 mm W x 15
in / 380 mm L x 11.18 in / 284 mm H.
1. Park the machine on a level surface, remove the
key and set the parking brake if equipped.
2. Lift the recovery tank to access the battery
compartment (Figure 1).
FIG. 1
3. Carefully install the batteries into the battery
compartment tray and arrange the battery posts as
shown (Figure 2). Insert the foam spacers as
shown.
4. Connect the battery cables to the battery posts as
shown (Figure 2). RED TO POSITIVE (+) and
BLACK TO NEGATIVE (--).
Machine Front
RED
BLK
105AH, 130AH
155AH
RED
BLK
Foam Spacers
105
A
H
FIG. 2
IMPORTANT: Make sure that the charger is
properly set for your battery type before charging
(See USING THE ON--BOARD BATTERY CHARGER
on page 16).