OPERATION
Nobles SpeedGleam
/Plus (01–02)
7
MACHINE INSTALLATION
UNCRATING MACHINE
Carefully check carton for signs of damage. Report
damages at once to carrier.
Check Machine Contents to ensure package is
complete. Contact distributor for missing items.
Machine Contents:
2 – Battery Cables #611116000
6 – Battery Cable Boots
1 – Battery Tray #604298
1 – Dust Bag, Cloth (Installed) #900210.
1 – Dust Bag, Paper #611781
1 – 20 inch Hair Blend Burnishing Pad (installed)
#611788–Carton of 5.
3 – 12V 215AH Batteries (Optional) #600394
1 – Battery Charger, 36DC/25A, 120V (Optional)
#469760868.
To uncrate your machine, remove shipping straps and
carefully lift or use a ramp to remove machine from
pallet. Do not roll machine off pallet, damage may result.
ATTENTION: To prevent machine damage, install
batteries after removing machine from pallet.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.
INSTALLING BATTERIES
WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and
open flame away. Keep battery compartment open
when charging.
FOR SAFETY: When servicing machine, wear
protective eyewear and gloves when handling
batteries or battery cables. Avoid contact with
battery acid.
Recommended Battery Specifications:
Three 12 volt, deep cycle, 215 amp hour batteries.
Part Number #600394. Maximum battery dimensions
are 178 mm (7 in)W x 394 mm (15.5 in)L x 362 mm
(14.25 in) H.
1.
Park the machine on a level surface.
2.
Turn the main power switch to the OFF position
and remove key, if equipped.
3.
Unlatch and hinge open both the dust bag hood
and the battery hood to access the battery
compartment.
Remove the two loose battery cables and cable
boots from the battery tray (Figure 1).
FIG. 1
4.
Carefully install the batteries into the battery tray
with the battery posts arranged as shown. Then
place the battery carrying handles on top of the
batteries to allow clearance for battery hood
(Figure 2).
MACHINE
FRONT
FIG. 2
ATTENTION: Do not drop batteries into
compartment. Battery and machine housing
damage may result.
5.
Using the cable boots, connect the battery cables
to the battery posts as shown, RED TO POSITIVE
& BLACK TO NEGATIVE (Figure 3).
Connect Last
BLK
MACHINE
FRONT
IMPORTANT:
Route cables to left
of machine to allow
hood clearance.
RED
BLK
RED
NOTE: Black wire #31
connects to negative
post on middle battery.
CHARGER
PLUG
BLK
FIG. 3
6.
Apply a light coating of non–metallic grease or
protective spray on the cable connections to
prevent battery corrosion.
Home
Find...
Go To..
