OPERATION
Magna Twin
t
1600/2200/2600 (10--04)
13
d. Rotate both bearing blocks 180
_
and reinstall
brush
(Figure 10)
.
NOTE:
Brush bearing blocks are labeled with
numbers. To extend brush life, position label “2”
outwards when reinstalling brush.
Rotate
Bearing
Block
FIG. 10
e. Replace metal brush shoe after brush is properly
installed.
OTHER
1. Inspect vacuum hose regularly for holes, loose
cuffs or clogged debris.
2. Inspect rear door gasket regularly for leakage.
Replace if worn.
3. Clean vacuum housing with damp cloth and mild
soap.
VACUUM MOTOR
Check Vacuum Motor carbon brush wear every 250
hours of use. Replace carbon brush when worn to
3/8” (1cm) or less in length. Vacuum motor damage
due to carbon brush wear is not covered under
warranty.
STORING MACHINE
Before storing machine, neatly coil power cord, clean
or replace filters and install a new filter bag. Store
machine in a dry area.
WARNING: Do Not Use Outdoors Or On Wet
Surfaces. Do Not Expose to Rain. Store Indoors.
RECOMMENDED STOCK ITEMS
Refer to Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description. See example below:
Home
Find...
Go To..
