OPERATION
6
265XP
(03-99)
OPERATOR RESPONSIBILITY
The operator’s responsibility is to take care of the
daily maintenance and checkups of the machine to
keep it in good working condition. The operator must
inform the service mechanic or supervisor when the
maintenance intervals are required as stated in the
MAINTENANCE section of this manual.
Read this manual carefully before operating this
machine.
FOR SAFETY: Do not operate machine unless
operation manual is read and understood.
After the first 50 hours (3 weeks) of operation the
following procedures are recommended:
Check the squeegee deflection.
Check the battery electrolyte level.
Check the battery cable connections.
RECEIPT OF MACHINE
Carefully check carton and machine for signs of
damage. If damaged, file claim with carrier
immediately. Concealed damage claims should be
filed within 90 days of receipt. Retain all packing
materials and delivery receipts for claim support.
BATTERY INSTALLATION
Battery installation must be completed before
removing machine from pallet. After batteries are
installed remove shipping screws (4) that mount front
and rear of machine to pallet. Create a ramp and
carefully push machine off pallet. Be certain that
scrub head is in the up position. See page 41 for
battery installation instructions.
BRUSH AND PAD DRIVER INSTALLATION
1.
Make sure the scrubber head is in the ”UP”
position, and the key switch is turned ”OFF.”
2.
Slide the brush or pad driver under the scrubber
head. Holding the brush or pad driver with both
hands, lift it up to the drive hub and snap into
position (Figure 1).
FIG. 1.
NOTE: Pads should be mounted to drivers before
installation, for proper centering.
3. To remove the brush or pad driver, push down on
the brush release pin, located on the scrubber
head, behind each scrub motor (Figure 2).
