Noblelift PS35LSL, Инструкция по эксплуатации

Страница: 18 / 28

17

The safety (belly) button (3) prevents the operator from being crushed. If this button is activated, the
truck decelerates and/ or starts travelling into the backwards direction (‘Bw.’) for a short distance
and stops. Please consider, that this button also operates, if the truckis not travelling and the tiller is
in the operating zone.
h.
Malfunctions
If there are any malfunctions or the truck is inoperative, please stop using the truck and activate the
emergency button (6) by pushing it. If possible, park the truck on a safe area, turn the key switch (8) anti-
clockwise and remove the key.
Inform immediately the manager and, or call your service. If necessary, tow the truck out of the operating
area by using dedicated towing/ lifting equipment.
i.
Emergency
In emergencies or in the event of tip over (or off dock), keep safe distance immediately. If possible push
the emergency button (6). All electrical functions will be stopped.
j.
Fork adjustment
（
PS 35L SL
、
PS 44L SL
）

Not fixed and improperly adjusted forks can lead to
dangerous accidents.

Check if the safety bolt (10) is installed before adjusting
the forks. If the safety bolt (10) is not in place, the truck
shall be prohibited to use.

When adjusting the fork, pay attention that the distance
between each fork and outer edge of the holder should be
same.

Clip the positioning pin into a fixi slot to avoid accidental
movement of the fork.

Load center must be located in the middle of the two forks.
Operation steps:

Park the truck securely according to the regulations.

Pulled up the positioning pin (13), make it away from the fixed slot.

Move the forks (14) to the appropriate position.
In order to ensure the operation safety of picking process, the distance
between the forks (14) should be as large as possible, and the fork position
must be symmetrical with the center line of the fork holder. Load center must
be located in the center of the forks (14).

Put down the positioning pin (13), move the forks until the positioning pin
clip into the fixing slot.
Fig. 12:Adjust the forks
Fig.13:Move the forks