Page 22 of 27
Part K.
SAFETY INFORMATION
USING YOUR FIRE TABLE / COLUMN
Before each use, inspect the Gas Hose(12). Replace the Gas Hose(12) if there are
any signs of cutting, wear or abrasion.
Before you light your Fire Table / Column, please proceed / adopt the following
steps :
1. Make sure the Control Knob(13) is in the “OFF” position.
2. Open the Door(07) and slowly open the Valve( 20) on the Propane Gas Tank by
turning the Contol Knob(13) counterclockwise.
3. Close the Door(07) on the Main Frame(06) of the Fire Table / Column.
4. Push and hold in the Electronic Ignitor(14 ) to create sparks within the electrode
continue to hold.
5. Push in the Control Knob(13) and turn to the “LOW” position.
Keep holding down the Control Knob(13) to allow gas to flow for 15 seconds.
6. If ignition doesn’t occur within a few seconds release the Control Knob(13) and
rotate to the “OFF” position.
Wait for 5 minutes for gas to clear and then repeat the above lighting instructions.
7. Once the Fire Table / Column is lit, the flame intensity may be controlled by
turning the Control Knob(13) between the “LOW” and “HIGH” positions.
9. Observe flame cokour and flame
height when the Fire Table / Column
after being lit:
9.1. ) Flame color should be yellow /
blue.
9.2. ) Flame height burns at 2 - 10
inches high.
8. Instructions on properly locating the gas hose including locating the hose out of
pathways where people may trip over it or in areas where the hose may be subject
to accidental damage.
After installing gas tank, check to prevent the gas hose from touching any heat or
sharps and make sure the door wouldn’t press into gas hose when closing the tank
holder door.
Noble House Home Furnishings LLC
Page 22 OF 27
