Black SPKR (–)
Red SPKR (+)
Speaker
Wiring
Speaker Wiring:
The N3 has long wiring, well protected in a wiring sleeve.
- You can cut the wiring to a desired length for a clean installation.
But, make sure to do so only after you finished installing your entire
audio system, including its amplifier.
- Connect the speaker wires to your amplifier ensuring correct polarity;
Red to positive and Black to negative.
Running your N3 wiring:
Run the N3’s wires along and attached the Bike’s cage/body
all the way to the amplifier’s location.
Use cable ties to ensure it will be kept away from sharp edges to avoid
the possibility of getting pinched by moving mechanisms.
...to ensure it is away...
Importnt featurs of the N3
Please read before first use
Handlebar Fitment:
Your N3 speakers can be mounted
on 7/8”, 1” & 1.25” handlebars.
Inside the N3 package are two
rubber inserts:
For 7/8” handlebar, use the
thicker rubber insert.
For 1” handlebar, use the
thinner rubber insert.
For 1.25” handlebar, no rubber
insert is required. simply mount the
bracket directly on your handlebar.
Choosing the right angle:
The N3 speakers can be mounted
in various angles.
The M8 screw found on the bottom of
the speaker can be loosened to allow
full rotation of the speaker. (see page 5)
The bracket itself can also be
rotated around the handlebar, allowing
you to mount the speaker above or
underneath the handlebar.
Replacing the speaker:
If, for any reason, you need to replace
your speaker, you can easily do it.
on the back of your N3 speaker you
will find a M6 Allen screw. using a M4
Allen wrench, unscrew this screw.
You can now take off your speaker and
replace it with new one.
For spare parts, contact us at:
[email protected]
