background image

TABLE OF CONTENTS

TABLE OF CONTENTS

SAFETY

3

  Federal Communications Commission (FCC) Statement

3

  Classification of LED Transmitter Device

4

INTRODUCTION

5

UNPACKING

6

ACTIVE PAIR SETUP

7

DESCRIPTION

8

CONFIGURATION

9

MODE DESCRIPTION

10

COLLAPSED RINGS

11

CONNECTIONS

12

INSTALLATION

16

  Host side multiplexer installation

16

  Device side multiplexer installation.

17

PROBLEM SOLVING

19

  The MULTIPLEXER ’s front panel power LED is off!

19

  A device is down or unstable!

19

  The MULTIPLEXER ’s TX LED is off!

19

  Devices interfere with each other!

20

  Devices cannot operate in Express mode!

20

  The MULTIPLEXER ’s RX LED is off or flashing!

20

WARRANTY STATEMENT

23

RETURN MERCHANDISE PROCEDURE

23

WARRANTY STATEMENT

WARRANTY STATEMENT

This NLynx product is warranted to be free from defects in material and
workmanship for a period of three years from the date of purchase.  NLynx’s
liability under this warranty is limited to cure, repair, or replacement of the
product.  NLynx shall not be liable for injury, property damage or other direct, or
direct consequential damage, including but not limited to loss of profits or other
damage or expenses arising directly or indirectly from the installation, removal,
maintenance, use or non-use of the product used separately or in combination with
other equipment.

These warranties shall become void where it is determined, at the sole discretion
of NLynx, that the product has been exposed to excessive physical or operational
abuse, acts of God, or theft.  Repairs performed by someone other than by NLynx
will void this warranty.  This warranty is in lieu of any and all other warranties,
expressed or implied, by NLynx representatives or distribution, including fitness
for particular purpose and merchantability.

The customer may, at their option, purchase an Assist Service Agreement that
would provide same day overnight shipping response for field replacement of
faulty equipment to maintain your data communication system while equipment
repairs are completed.  Contact our Sales department for further details.

RETURN MERCHANDISE PROCEDURE

In the event that the product is not as warranted, the customer must contact NLynx
for a return merchandise authorization number (RMA#) before returning the
product to the NLynx facility in Austin, Texas, USA.  Out of warranty repairs are
available on a time and materials basis.  The customer must contact NLynx for a
return merchant number (RMA#) prior to shipping the malfunctioning unit to
NLynx.  The customer is responsible for all shipping and insurance charges to and
from NLynx facility in Austin, Texas, USA.

NLynx Technologies

8313 Highway 71 West

Austin, Texas USA

Toll-free: (800) 328-2696

Tel.: (512) 301-8000
Fax: (512) 301-8030

 

www.nlynx.com

Содержание GEMINI EXPRESS MULTIPLEXER













Отзывы: