NKT Photonics Koheras ADJUSTIK, Руководство по эксплуатации продукта

Страница: 58 / 105

Enabling and disabling emission
58
Enabling and disabling emission
Enable emission
(CONTROL)
To turn on the laser using CONTROL follow the steps in
Procedure 3
.
Note: The laser is equipped with internal temperature sensors that monitor the
temperature of sensitive components. If these components are outside their
specified temperature range, the laser source will halt emissions.
Procedure 3 Turning on the laser using CONTROL
Action
1 Connect to the laser using the procedures in Communicating with the Laser on page 53 .
2 If Interlock in the status panel is RED and
Status is AMBER, check the following:
1. The door interlock circuit is open –
Connecting the safety interlock on page 83
2. The external bus is not looped back with a
bus defeater – Connecting the safety
interlock on page 83
3. The key switch is set to OFF – proceed to
step 2.
3 Turn the key switch on the front panel to the
ON position.
4 To enable emission, click the Emission button
once.
The emission indicator (next to the Emission
button) turns RED
The Status indicator turns:
•
GREEN – the laser is operating normally
•
Flashing GREEN – the laser has not reached
operating temperature (warming up)
•
RED – a system ERROR or interlock opened
with emission enabled. (Emission will be
disabled.)
Interlock Indicator
RED and Status
AMBER
ON
OFF
Interlock
Indicator
GREEN
Click
Emission
(ON)