PIPE BEVELING MODE
PIPE BEVELLING DIAMETER OF 150 - 300 mm
It is necessary to dismount the rollers and put them into a diagonal grooves on the guiding table.
1.Attach the rollers in pitched grooves and gently tighten them by hand
2. Attach B16 Zero on the tube and adjust the position of the rollers to the outer circumference of the
tube
3. Tighten the rollers (rollers position must be adjusted at each change of the pipe diameter)
4. The set of bevelling of the flat materials it is necessary to return the rollers back to the holes of the
table. Place the special nut so they lean on the wider side on the table.
PIPE BEVELLING DIAMETER OF 300
– 600 mm
For even larger diameter pipes, there is an optional large pipe bevelling table plate which can bevel
pipes 300mm up to 600mm (ordering number 26229). This bevelling table is an optional device. Simply
unbolt the four socket cap screws to remove the standard table plate and bolt on the optional table plate
in its place. Tighten it back with the four screws.
