When the 6th channel is between 1 and 24:
The first channel is the master dimmer.
The second channel sets the colour.
The third and fourth channels are not used.
The fifth channel sets the strobe speed.
When the 6th channel is between 25 and 249:
The first channel is the master dimmer.
The second, third and fourth channels are not used.
The fifth channel sets the strobe speed.
The sixth channel selects the program.
When the 6th channel is above 250 change-colour-to-sound is
selected.
The first channel is the master dimmer.
The second, third and fourth channels are not used.
The fifth channel sets the strobe speed.
The 7th channel can be used to extend the addressing range by
allowing up to 66 NJ179 luminaires to be individually controlled from
the same eight DMX addresses. This mode is switched off when the
7th channel is below 9.
To use this mode, set the luminaire ID by pressing SETUP repeatedly
until
id
is shown in the first two characters of the display. Then use
the UP and DOWN buttons to set the ID.
To control any particular luminaire, set the level of the 7th DMX
channel to the level corresponding to the ID of the luminaire in the
following table.
DMX level
ID
0—9
All IDs
10—19
ID1
20—29
ID2
30—39
ID3
40—49
ID4
Page 6
