•
For indoor use only.
•
Do not use in bathrooms, or in wet or damp locations.
•
Do not place the mains lead beneath a carpet or rug.
•
Do not allow the cable to hang over the edge of a table.
•
Arrange the cable so that it cannot cause a trip hazard.
This symbol means that the luminaire should mounted at
least 0.3 m from any object that it is illuminating.
0.3m
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician
at least once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the
wiring must be inspected at least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is
mandatory for new buildings). Ionisation-type smoke alarms are
recommended for buildings where theatrical fog effects are to be
used.
OPERATION
There are 5 modes of operation: Built-in programs, Auto-run, Slave,
Sound and DMX. These are selected using the MODE pushbutton
switch on the rear panel.
BUILT−IN PROGRAMS mode
Press the MODE button repeatedly until
Pr
is shown in the first two
characters of the display. Then use the UP and DOWN buttons to
select the required program.
Pressing the SETUP button allows other functions to be changed:
In programs 2 to 10, the following parameters can be adjusted:
FS
= flash frequency
SP
= run speed
Fd
= fade time
Each of these parameters can be changed by pressing the UP and
DOWN buttons.
In program 1 the colour can be set. Press the SETUP button then
press UP or DOWN repeatedly to select the colour.
The colour available are:
Page 3
