NIXER PD Dante, Руководство пользователя, Страница: 12 / 43

PD Dante version 2.02 rev a - 31/10/18
12
Right View
Right view of the PD Dante showing the micro USB AB connector which can be used to
power the unit. The unit can be powered by either USB or PoE. Both power inputs can be
used together for PSU redundancy. The USB port is also used for firmware upgrades for the
PD Dante
When powering the PD Dante from a PC/Laptop port it will need to be a high power (up to
2.5A) port to work. Please check your computer manual for information on this.
Next to the USB port is a 3.5mm (1/8inch) jack for headphones connection. This connector is
compatible with Apple iPhone headsets allowing the use of the microphone for talking back
into the Dante network.
Next is another 3.5mm (1/8inch) jack socket for connecting unbalanced stereo line playback
devices such as iPod, iPhone etc.
Again, this allows this signal to be injected into the Dante network
The final connector is a 15way D-type (pinout after specifications)
This has a balanced AES EBU input, balanced AES EBU output, Balanced Line Outputs for
L and R mix and Power/TX/RX remote control lines
A breakout lead for this connector is available separately
Power
Firstly, connect the PD Dante Primary port to a Dante Network
Then to turn on your PD Dante just apply a power source to either the PoE or USB
You will see the PD Dante splash screen which will give information on the Firmware
version and FPGA version.
After a few seconds, you will see the main input screen shown on the next page