NIVELCO THERMOPOINT TM/J-500, Руководство пользователя и программирования

Страница: 13 / 28

tmh5554a0600p_06

tmh555en2106p

13 / 28
5. COMMISSIONING AND PROGRAMMING
TM  −  , TJ  −  instruments can be adjusted and programmed with the SAP − 300 display unit.
Without the SAP − 300m, the following LED signs are possible:
 VALID Indicates the readiness of the unit. If it is continuously on, the input signal is stabilized.
If it is blinking, the input signal is changing.

COM Indicates digital (HART) communication. During remote programming, the LED is continuously on.
When the SAP
− 300 display is present, it covers the LEDs; their functions are taken over by the display. In its default state, the
SAP display shows the table of the measured temperature values (see chapter 5.1 ).
Programming is supported by a text-based menu. Navigation is done by using the
E
/ / / buttons.
The instrument can operate without the SAP-300 module as well. Programming can be done only by using SAP − 300 display
module locally or by HART (REMOTE PROGRAMMING) communication system remotely.
The SAP − 300 is a 64x128 dot-matrix LCD display, which can be plugged into the transmitter. (The unit is universal, it can be used
in other NIVELCO devices, provided that the system software supports SAP − 300.)
Warning!
The SAP − 300 module is based on LCD technology! Make sure it is not exposed to continuous heat or direct sunlight to avoid
damaging the unit. If the instrument cannot be protected against direct sunlight or temperatures that are beyond the standard
operating temperature range of the SAP
− 300, remove the SAP display in the instrument.