Nittoh UP-45SV Series, Руководство по эксплуатации и обслуживанию

Страница: 6 / 17

5
3 Instructions before use
3-1 Confirmation of all components for shipping damage or oil leakage. If any shipping
damage is found, notify carrier at once. Shipping damage is not covered by warranty.
The carrier is responsible for all repair or replacement costs resulting from damage in
shipment.
3-2
Oil feeding plug CAUTION
Use it after 2
～ 3 turns loosens a plug.
3-3 Confirmation of your power supply WARNING
Power supply is 220V 50/60Hz single phase. Make sure that a grounded outlet or a plug
adapter with a grounding attachment must be used.
3-4 Confirmation of hydraulic oil WARNING
Always check oil level before operation, with the connected cylinders fully retracted
(extended if pull cylinders). In case oil is added with cylinders fully extended and then
cylinders are retracted, the returned oil will overflow in the reservoirs, causing
generation of high pressure in the reservoirs, confirm required oil volume in a reservoir
as follows;
① Retract the connected cylinder fully.
② Check the oil gauge and confirm if oil is feeded up to half of the gauge. If oil is short,
not reaching the half of the level gauge, replenish oil. (See 5-1 kind of hydraulic
working oil).
4 Operation
“
UP-45SVG-0 ” with P.T. manifold, but without any operation valve.
1 Plug in the pump.
2 The P.T. manifold has a delivery port and return port. Depress “ON” operation switch to
run the motor pump to deliver oil. A remote mounted type operation valve is usually
installed between the pump and cylinder in such an application as where the pump is
far away form an operation position.
“ UP-45SVG-1 ” with MVS-3 2-way manual valve.
1
Plug in the pump.
2 Close release valve lever by turning clockwise (stop at 45 ° )and depress “ON” switch
to advance the cylinder.
3 To retract the cylinder, return the lever to the original (front) position.