(2) Make sure that both the Magnet adhesion surface
and the workpiece surface are clean.
CAUTION
If foreign matter is caught between the surfaces,
there is a danger that the tool may be spun around.
Gaps between the Magnet adhesion surface and the
workpiece weaken the magnetic holding power. Always
keep the Magnet adhesion surface free from foreign
matter (such as metal chips), unevenness, and rust.
(3) Align with punch hole
Turn the Rod Handles in the counterclockwise
direction to lower the cutter gently and align the tip of
the Pilot Pin with the punch. (Fig. 28)
(Fig. 28)
(4) Magnet on
CAUTION
Make sure the Magnet is clinging to the workpiece.
Turning the switch to the Magnet On position causes
the Magnet lamp to come on and activates the Magnet.
(Fig. 29)
(Fig. 29)
(5) Stabilizer adjustment
CAUTION
The Stabilizer serves to use the adhesive force of
the Magnet effectively. After switching on the
Magnet, adjust it so that the Magnet clings to the
workpiece. Make sure the Stabilizer is not protruding
too far and lifting the Magnet. (Fig. 30)
(Fig. 30)
(6) Cutting Oil control.
When the P-Valve on the Oil Tank Bracket is open
and the Drill Motor is lowered by turning the Rod Handles
in the counterclockwise direction, the Pilot Pin will be
pushed up allowing the Cutting Oil to begin to flow.
Adjust the oil flow rate by observing the Oil Dropper on
the front of the Drill Motor. (Fig. 31)
(Fig. 31)
(7) Drill Motor on
CAUTION
Do not touch the rotating parts.
Turning the Switch Knob to Motor On position starts
the Drill Motor running. (Fig. 32)
(Fig. 32)
12
Lower partially
ON
OFF
ON
MAGNET
MOTOR
Switch Knob
Nut
Stabilizer
P-Valve
ON
OFF
ON
MAGNET
MOTOR
Switch Knob
QA4000(230V)
10.6.19, 12:52 AM
Page 13
Adobe PageMaker 6.0J/PPC