Nitto QA-4000 Скачать руководство пользователя страница 11

Страница: 11 / 24

・

If mist or vapor has been inhaled, immediately transfer

the patient tot fresh air, cover his/her body with a
blanket and keep warm and quiet. Consult a physician
and follow the instructions.

・

If it has been ingested, immediately give copious water

and induce vomiting. Consult a physician and follow
the instructions. If the patient is unconscious, do not
administer water or induce vomiting.

(4) In Case of Fire

・

For a fire in the vicinity, wear protective equipment

and extinguish the fire from upwind with foam, powder
or CO

fire extinguishers.

(5) Method of Storage

・

Seal after use to prevent admixture with dirt and/or

water.

・

Store in a cool dark place away from direct sunlight

and rain.

(6) Method of Disposal

・

Disposal of undiluted and diluted fluid should be

handled as waste fluid in accordance with the law by
a waste disposal specialist.

・

Wash water should be treated by pH adjustment,

flocculation and settling, activated sludge treatment,
activated carbon adsorption, etc., and discharged in
accordance with municipal standards.

・

Since empty containers contain dregs, they should be

handled with care.

(7) Other

・

If transferred to other containers for use, the names

of chemicals used in the workplace and the labeled
contents should be displayed and kept together with
the Instruction Manuals ready for immediate perusal.

・

Anyone wishing to have further details may request

product safety data sheets from manufacturer.

・

The inscribed details are based on currently available

information and data and updated by new knowledge.

・

Items to be noted are aimed at normal handling.

Where special handling is involved, safety measures
appropriate to the application and method of handling
should be implemented.

・

The inscribed details are submitted for your information

and do not imply assurances or acceptance of
responsibility.

5-8-1 Preparing the Cutting Oil
(1) Use our authentic Cutting Oil (light blue). Cutting
performance and cutter life may be reduced if other
Cutting Oils are used.

(2) Dilute the Cutting Oil eight to ten times with tap water.

(3) The Oil Tank is a cartridge type tank. Remove it
from the Oil Tank Bracket and fill it with Cutting Oil away
from the tool so that oil will not be spilled on the tool.
The Oil Tank should be installed so that its cap fits in
the Oil Tank Bracket. (Fig. 22) When drilling is being
conducted on a continuous basis, it is recommended
that another tank be prepared so that operations can be
continued easily by just changing the Oil Tank, even
when the oil in the former tank runs out during the
operation.

(Fig. 22)

5-8-2 Flow Rate Control

The Cutting Oil flow is controlled by adjusting the P-

Valve on the Oil Tank Bracket and observing the Oil
Dropper on the front of the Drill Motor. As a guide for
the oil feed rate it is generally recommended that the
slags (chips) be kept constantly wet during the drilling
and free from discoloration due to burning etc. The flow
rate adjustment should be performed during drilling or
when the Pilot Pin is depressed after lowering the Drill
Motor. The P-Valve should be closed when operations
are interrupted for a long period of time. (Fig. 23)

(Fig. 23)

5-9 Inserting the Power Plug into the Power Source

CAUTION

Set the switch to Off before inserting the Power Plug.
The power supply voltage used must be correct.

6 HOW TO OPERATE THE TOOL

4 ELECTRONIC CONTROL FUNCTIONS

Part No.

Part Name

TB03700

Oil Tank Ass'y

Oil Dropper

Oil Tank