4
INSTRUCTIONS FOR
THIS TOOL
Warning
●
Wear protective glasses and a dustproof mask
Operation generates chips and dust particles,
etc. which may cause eye and/or respiratory
injury: Always use PPE (Personal Protective
Equipment) for eye and respiratory protection.
●
If discomfort or pain is encountered during use,
you should cease operations and check with
your physician.
●
Be sure to keep hands clear of moving parts.
●
Always turn off the air supply and disconnect
the air supply hose before replacing or adjusting
a file and a part on the tool.
Caution
●
Use NITTO genuine parts files and pads.
●
Use of the ones other than NITTO genuine parts
may cause abnormal vibration or defective
finishing surface.
●
The weight of the accessory for this tool should
be 12~15g.
1. APPLICATION
This tool is for filing the workpieces using the exclusive
file.
2. RECEIVING INSPECTION
Upon unpacking, check to see that the shipment is
complete without damage or oil leakage in transport.
Should you find any damage or short-shipment,
please contact sales agent through which you have
purchased your machine or an authorized dealer
near you for corrective actions.
Package Content
Q’ty
SUPER HAND ASH-800
1set
Rat Tail File SF-10
1
Triangular Taper File SF-11
1
Half Round File (Rat Tail / Double
Cut) SF-12
1
Flat Bastard File SF-13
1
Hex. Wrench Key 2.5
1
Bushing PT1/4×NPT1/4
1
Instruction Manual
1
3. AIR SUPPLY
3-1. Air Pressure
Adjust air pressure with the air regulator to the level
appropriate for the pneumatic tool used.
Air pressure that is too low fails the tool to operate at
full capacity.
Air pressure that is too high may cause damage to
the tool.
3-2. Air Line
(Fig. 1)
Use a 9.5 mm (3/8”) connecting hose between the
compressor and the tool.
Drained water, etc., if flown into the tool, could
cause tool failure. Install an air filter. between the
compressor and the tool.
Air Regulator
Oiler
Air Filter
C
o
m
p
r
e
s
s
o
r
TOOL
9.5mm (3/8 in)
Hose
Fig. 1
3-3. Lubrication
Caution
●
Always lubricate with a few drops of oil (ISO
VG-10), 2 to 3 times a day.
Install an oiler between the compressor and the
tool. Use Machine Oil #10. Failure to lubricate
causes damage to the tool. Lubricating oil with high
viscosity degrades tool performance.
Содержание ASH-800
Страница 9: ......
Страница 10: ...Printed in JAPAN TQ05087 5 SUPER HAND Model ASH 800 PROFESSIONAL TOOL...