11
EN
WARNING
z
Always inspect the Spindle's threaded part and Outer Flange for breakage, deformation and wear.
,IDQDEQRUPDOLW\LVIRXQGVWRSXVLQJWKHWRROLPPHGLDWHO\
z
Never use the side other than the usage surface of the Grinding Wheel.
z
Be sure to install a Wheel Guard on the air grinder having a tip Grinding Wheel tool maximum diameter of 50
mm or more.
z
Be sure to use the Wheel Guard provided with this machine.
Use of equipment other than as specified could cause an accident.
z
Always replace damaged, deformed, or excessively worn Wheel Guards.
Do not use a Wheel Guard that could cause damage to the Grinding Wheel.
z
The intake air pressure during operation of this tool should not exceed 0.6 MPa.
z
Do not abruptly operate or stop the tool.
:KHQVWDUWLQJEHVXUHWRRSHQWKH7KURWWOH/HYHURU9DOYH5LQJJUDGXDOO\
z
When performing any work, before attaching the Grinding Wheel be sure to use a tachometer to check the no-
load rotation speed of the tool.
Make sure the Valve Ring of the main unit is at the maximum rotation position and that the rotation speed at 0.6
MPa does not exceed the rotation speed stated on the Wheel Guard.
$OVRZKHQ\RXXVHWKLVXQLWDIWHUUHSDLUFKHFNLQWKHVDPHZD\
z
During trial operation, make sure that there is no one near the rotating Grinding Wheel.
z
At startup, push the Grinding Wheel slowly against the workpiece until the Grinding Wheel gets warm.
z
Always work at the correct angle of 15 to 30 degrees.
15 to 30°
Use surface
