7
the power plug from power supply whenever
adjusting chamfering angle.
(1) Loosen the Hex. Socket Head Cap Screws
①
(4pcs) on both ends on the Plate Guide
②
of Head
③
. (Fig.6)
(2) Move the Plate Guide
②
so that the scale of
desired angle can align to the Guide Mark
④
.
(3) Tighten the Hex. Socket Head Cap Screws
①
.
The tool has the limit of chamfering width which
depends on a chamfering angle. (Fig.7, Table.1)
Guide Mark
④
Head
③
Scale to adjust
Chamfering angles
Hex. Socket Head
Cap Screw
①
Plate Guide
②
Plate D
Plate C
Fig.6
α
A
B
C
Fig.7
Chamfering
Angle
Stainless
Steel(mm)
Mild Steel(mm)
α
A
B
C
A
B
C
45°
3
3
4.2
7
7
9.9
30°
2.2
3.8
4.4
3.8
6.6
7.6
15°
1
3.8
3.9
1.5
5.6
5.8
Table.1
5-5. Before Cutting
(1) When you start to work from the corner as shown
in Fig.8, cut off the corner first with grinder etc.,
then start.
Cut off the corner
Cutting direction
Fig.8
(2) Before start chamfering, make sure that the Switch
is set on and the Indexable Insert is rotating. Then,
apply the tool to the workpieces.
The Indexable
Inserts may be damaged if the Switch js set
on after Indexable Inserts are pressed on the
workpieces or they may also be damaged if they
are pressed to the workpieces abruptly.
(3) The workpieces should be fixed as much as
possible while working.
5-6. Feeding Speed
Be sure you should avoid quick feeding or heavy
shock. Please refer to Table.2.
Stainless Steel
3cm/sec
Mild Steel
2cm/sec
Table.2
5-7. How To Operation
WARNING
●
Be sure to turn the switch OFF and remove
the power plug from power supply whenever
adjusting chamfering levels.
●
The workpieces should be fixed as much as
possible while working.
(1) Select the chamfering level.
(2) Make sure that the Switch is set at “OFF” position
and connect the power plug to the power supply.
(3) Hold the Housing up. Start the tool.
(4) Hold the Housing and Knob firmly. Apply the
tool on to the workpiece along with the direction
(shown on the Plate C) carefully.
In case of chamfering stainless steel, chamfer deep to
the desired chamfering level by one span of operation.
Repeat of chamfering makes the life of Indexable
Insert shorter.
5-8. Radius Chamfering
●
By using radius chamfering Indexable Inserts, radius
chamfering job can bedone.
●
Radius chamfering Indexable Insert is an optional
accessory.
(1) Select the radius chamfering.
(2) Make sure that the Switch is set at “OFF” position
and connect the power plug to the power supply.
(3) Hold the Housing up. Start the tool.
(4) Hold the Housing and Knob firmly. Apply the
tooI on to the workpiece along with the direction
(shown on the Plate C) carefully.
