Nitto Kohki EJC-32A, Инструкция по эксплуатации

Страница: 5 / 12

4
6 HOW TO OPERATE THE TOOL
WARNING
Always wear eye protection.
Everyday eyeglasses only have impact
resistant lenses. They do not protect eyes.
Also use face or dust mask, if operation
creates dust.
6-1 Start And Stop
WARNING
Always switch off before it is plugged in.
q
Depress the Trigger Switch in the direction of "ON" in the
Switch Handle. The Needles work. When the button in the
Switch Handle is pressed, the operation switch is locked (on).
[Fig 4]
[Fig 4]
w
When the work is completed, keep the hand apart from the
operation switch and make it off. When the operation switch
is locked, pull it once again to unlock.
●
It is not necessary to press the tool against the work. It is
good enough to support it so that Needles are in the right
track of the operation.
●
When it is operated with pressure more than necessary, it
may cause the Needle bent/broken or the tool damaged.
●
Needles are consumable. When even one piece is broken,
stop the operation promptly, take the left head of the Needle
and substitute a new one for it. If the operation continues
with the Needle head left, it will cause in the early stage the
damage of the Needle Supporter and abnormal operation.
OFF ON
Switch
Push Button
Oil
Oil Cup
7 MAINTENANCE AND INSPECTION
WARNING
When performing maintenance, inspection,
replacement or adjustment of parts, make sure
to disconnect the attachment plug from the
receptacle.
Check regularly if there is any place where fixed
screw becomes loose. If there is some, fasten
again.
7-1 Oiling [Fig 5]
Before use and 3~4 hours after start of the operation, never
fail to oil about 1cc of machine oil #10 from the opening of the
Anvil Guide. If dense oil is used, it may cause malfunction.
[Fig 5]
7-2 Grease pouring [Fig 6]
Grease is used in the Gear. It should be poured with a grease
gun from an Oil Cup once a month.
[Fig 6]