Nitto Kohki DEA0151N-AZ, Инструкция по эксплуатации

Страница: 10 / 62

8
EN
6 Appendix
Troubleshooting
Symptoms Location to investigate Solution
The electric screwdriver
does not
operate
Is the power plug inserted into an
outlet?
Is power supplied to the outlet?
Properly insert the power plug into the outlet.
Check the power supply.
Is the power switch set to OFF (

)? Set the power switch to ON ( I ). (p. 7)
Is the electric screwdriver properly
operated or set?
Refer to the instruction manual for the electric
screwdriver.
The electric screwdriver
stops before torque-up
Did you check the model of electric
screwdriver and the power supply
model?
The power supply differs depending on the model
of electric screwdriver. Refer to the attached "List of
Electric Screwdriver Models".
Maintenance and inspection
WARNING
 
Before performing maintenance and inspection, always turn off the power.
 
Do not disassemble or alter the tool.
 
Use genuine parts.
CAUTION
 
For repair or part replacement, ask your dealer.
Repair requires special knowledge and skills. If repair is performed at a place other than a specialty store, the
tool may not demonstrate its full performance or it could lead to an accident or injury.
 
Request repair with the failed status kept intact.
When requesting a repair, do not throw away damaged parts. It could be important information for investigating
the failure cause so do not change the status.
Inspection locations CAUTION
Cable
Failure to perform inspection could result in fire or electric shock.
 
Check if cables are damaged and if found, stop using the tool.
 
Do not store the cord by wrapping it around the main unit. If it is stored with the cable wrapped
around the main unit, immediately change the storage method.
Power plug
Failure to perform inspection could result in fire or electric shock.
 
Check for damage on the power plug. If damaged, stop using it.
 
Check if the power plug has dust or metallic material adhering to it. If attached, disconnect the
power plug and use a dry cloth to remove it.
 
Check that the power plug is property inserted into the outlet all the way to the base.
 
Check for play in the power plug and outlet.
Main unit
 
Check for damage, cracks or breaks on the main unit.
Care
 
If the main unit is stained, use a cloth soaked in soapy water and wrung out well to wipe off the
stain. The tool does not have a waterproof structure and if water enters inside, it could fail.
 
Because the main unit uses plastic, the following chemicals cannot be used.
Acetone, benzine, thinner, ketone, ether, trichlorethylene and other similar chemicals
TV07527-1̲DEA0241N-AZ̲en̲fr̲de̲it̲es̲pt.indb 8 2017/07/04 13:09:15