Technical Manual: ST-PY-AS - 000026 (Changes are subject to DCRN)
Section 9 - PROGRAMMING THE
ST-PY-AS USING THE
MTM PROGRAMMER
1) Insert batteries, 2x9v PP3. and switch on Power Switch.
2) The LCD will show “Ver 1.0D”, and Power LED will light after the
LCD will blank (to save power).
3) Plug ST-PY-AS into base, and press “Search” button
4) LCD displays “WAIT….”
5) Then current address “xxx”, and Type “O” (for Optical for
example), and prompts for address to be entered.
6) Press “UP” or “DOWN” Button.
7) A Single press increments (or decrements) by 1, holding the
button down speeds up the increment (or decrement) change.
8) Select the desired address, and press “Set”
9) LCD displays “WAIT….”, then new address , Type and “OK”
(and beeps)
10)Remove detector and repeat from step 3
11)If no keys are pressed for 1 minute, the programmer will power
down into a power saving mode (LCD goes blank). It will be
necessary to press “Search” or switch the Power Off and back
On again.
Date:
16.04.09
Issue:
2
• sensortec • ST-PY-AS
• analogue addressable photoelectric sensor
instruction manual
sensortec
sensortec
7
