DW1500110 Rev.K1
Sep 18 2015
1
Instruction Manual
EVCA-P
Conventional Photoelectric Smoke Detector
Before Installation
Please read these instructions carefully and keep for future reference.
The information in this document is subject to change without notice. For updates please refer to our website.
Do not use the products outside the rated power supply voltage range specified in
the Specifications. It may cause a fire or damage to equipment.
! CAUTION
Do not disassemble, repair, or modify the products. It may cause a fire or electric
shock.
! CAUTION
Make sure to turn the power off before commencing any wiring work. Otherwise it
may cause electric shock or damage to equipment.
! CAUTION
Note:
Follow the requirements for the installation of the products in accordance with the Specifications. Otherwise it
may cause malfunction.
Note:
Do not install the product in any location where oil, dust, iron powder, chemicals, or hydrogen sulphide may occur
or affect the product. It may cause damage to equipment.
Section 1
–
INTRODUCTION
1.1
General description
The
EVCA-P
is an attractively-styled, low profile photoelectric smoke detector for use in conventional fire detection
systems. This detector is also for use in analog fire alarm systems, the Nittan control panel NFU-7000 series, when the
detector is connected to the analog addressable module EVA-ZMU-SCI Zone Module.
1.2
LED Indicator
LED Indicators for 360° visibility (OMNIVIEW
TM
360°) of
EVCA-P
operate as follows:
Red LED illuminates in an alarm condition.
NITTAN COMPANY, LIMITED
1-54-5 SASAZUKA, SHIBUYA-KU, TOKYO 151-8535, JAPAN
http://www.nittan.com
