Nitta PolySprint NPS-0310H1, Руководство по эксплуатации

Страница: 16 / 24

- 15 -
③ Heating Belt
Be sure to wear anti-heat gloves in
the following procedures.

Check the current temperature of the press to see
if it has been heated up to the set temperature.

Grasp the press handles and open the mouth of
the press.

Hold the pre-setter clamps and set the pre-setter
in the heat press.
※ Be sure the pre-setter is set as shown left.
Do not set it upside down or it may cause an
unsuccessful joint. (Place the bottom plate of
the pre-setter on the bottom part of the heat
press, and the top plate of the pre-setter under
the top part of the heat press.)
※
Position the pre-setter so that it is centered in
the press.
※
Insert the pre-setter all the way into the press
until it touches the hinge.
Top part of Heat Press
Bottom part of Heat Press
Top part of Pre-setter
Bottom part of Pre-setter
WARNING
Centre the pre-setter in the heat press.
Make sure that the
pre-setter touches
the hinge.