![background image](http://html1.mh-extra.com/html/nissen/bakolight-led-gps-2-l8g/bakolight-led-gps-2-l8g_operating-instructions-manual_1695988021.webp)
© 2017 Adolf Nissen Elektrobau GmbH + Co. KG
ENGLISH
BakoLight LED GPS/2
21
Low voltage indication
If the voltage of the battery sinks below 4 volt, the lamp blinks every 2 seconds (normally every
second) for minimum 16 hours.
Others
Function of the LED on the circuit board:
The LED has several monitoring functions. When switching on the pulser the function of the position
switch can be checked. The LED blinks according to the position of the switch (once for position 1,
twice for position 2, tenfold for position 0 etc.).
At normal blinking light operation the synchronisation by the GPS signal is indicated. When LED and
lamp are blinking together it is synchronous. When the LED stays dark the lamp is not synchronous.
Removal of the circuit board
•
Remove the lens.
•
Disconnect the connections of the screw clamp and take out 4 screws of the circuit board.
•
Take out the circuit board.
CAUTION!
Disconnect the battery before removing the circuit board!
2.4
Mounting
Mounting on beacons and saftey barriers
:
•
Lower the security screw on the side.
•
Mount on beacon or similar.
•
Fasten and save the BakoLight by turning the security
screw.
Mounting of BakoLight with firmly mounted bracket:
•
Click back the strap click to lay the clip on the thumb or
tube.
•
Click over the strap click and fasten the nuts with the
NiKo-key.
Mounting of BakoLight with firmly mounted bracket
on safety barriers:
•
Remove the screw with the NiKo-key.
•
Push the lamp including bracket under the edge of the
safety barrier.
•
BakoLight with firmly mounted bracket can be fastened
on the barrier.
Содержание BakoLight LED GPS/2 L8G
Страница 2: ......