ninjakitchen.eu
ninjakitchen.eu
33
32
USING THE JUICER
ENGLISH
7
Select START/STOP, then gradually add
ingredients to the feed chute. For best
results, allow juicer to process each
ingredient before adding more to the
feed chute. Use the tamper to push
ingredients down through the feed
chute, as needed.
8
When juicing is complete, select
START/STOP, then close the anti-drip
lever. Stir juice and serve. Residual pulp
will be deposited in the pulp container.
9
To disassemble, press and hold the
RELEASE button while turning the feed
chute chamber clockwise and remove
from motor base.
10
Remove the pulp spout from the feed
chute chamber by turning clockwise
to remove the outer pulp spout, then
twist the inner pulp spout clockwise to
remove. Remove the filter and auger by
gently pulling out of the feed chute.
11
Unplug the unit when finished. If
moving the unit, grab from the bottom
of the base. Refer to the Care &
Maintenance section for cleaning and
storage instructions.
1
Plug in motor base and place on
a clean, dry, level surface such
as a worktop or table.
2
Insert the auger into the feed chute
chamber, then attach the desired filter
onto the auger, with the metal portion
of the filter on the bottom of the auger.
3
Attach the inner pulp spout to the
feed chute chamber by installing at an
angle, on top of the filter, then turning
anti-clockwise to lock in place. Ensure
the word Ninja is facing upwards. Then
attach the outer pulp spout by installing
at an angle, on top of the inner pulp
spout, and turning anti-clockwise to lock
in place.
4
Install the assembled feed chute
chamber on the motor base at an
angle, then turn anti-clockwise until
it clicks into place.
IMPORTANT:
Review all warnings on
pages 28-29 before proceeding.
5
Install the food tray on the top of the
feed chute.
6
Place the pulp container under the pulp
spout, then place the juice jug under
the anti-drip lever on the feed chute
chamber.
Align the metal portion
of the filter with the
bottom of the auger.
Make sure the
anti-drip lever
is open before
juicing.
NOTE:
If the feed chute chamber becomes
blocked or ingredients are not processing,
press and hold REVERSE. There will be a
beep and a brief pause, then the auger will
rotate in the opposite direction. Release
REVERSE to stop. Repeat as needed. Press
START/STOP to resume normal operation.
NOTE:
Refer to the Recipe Guide for ideas
of how to use the leftover pulp.
IMPORTANT:
DO NOT
add frozen fruits
and vegetables or ice to the unit.
ASSEMBLY
JUICING
DISASSEMBLY
