17
14
4
22
25
1
2
4
Risk of damage!
Sewing
If you are not sure whether the thread tension or stitch type, for example, is
correct, test the settings on a swatch.
The fabric will run through automatically under the presser foot. It should
not be held fast or pulled by hand, but should only be gently guided so that
the stitches go in the desired direction.
TIP
19
Switch on the main switch .
When changing the stitch type, always move the needle to its highest position by
turning the hand wheel toward you. Raise the presser foot lever.
Push the fabric sufficiently far under the presser foot . Make sure there is a length
of around 10cm of the upper and lower thread behind the needle.
Lower the presser foot lever . Holding the thread with your left hand, turn the hand
wheel towards you and lower the needle to the point on the fabric where you want
to start sewing.
Press the foot pedal or slide the speed switch to right to start sewing.
While sewing, guide the fabric gently by hand.
Sew a few reverse stitches by actuating the reverser lever in order to fix the first
stitches in place.
Selecting the right needle
Using a defective needle can cause damage to the material.
− Replace defective needles immediately.
The number indicating the needle thickness is written on the shaft. The
higher the number, the thicker the needle.
It’s better to develop a habit of turning the hand wheel toward you
(as shown), especially when the upper thread is already threaded.
Otherwise, the machine will be knotted by the thread in the hook.
STOP
SLOW
FAST
