7
41840-A McAlby Court, Murrieta, CA 92562
(800) 451-9343, email: [email protected]
For easier installation, attach all tubing prior to mounting the
faucet.
1. Insert polished faucet base onto base of faucet.
2. Push the 1/4” yellow drain tubing onto the 1/4” barb fitting.
This tube must be of sufficient length to reach the yellow
drain connection on the manifold.
3. Push the white 3/8” tubing onto the larger 3/8” barbed
fitting, being sure you have enough tubing to reach the drain
saddle.
4. Slip the 1/4" and 3/8" tubing though opening in polished
faucet base. Slide white plastic spacer open-end-up onto the
threaded faucet stem (2).
5. Thread the 3/8" washer (3) and mounting lock nut (4) onto
the threaded stem. (Fig 6)
6. Thread faucet quick-connect adapter (5) on to threads of
faucet stem. NOTE: This connection should be hand-tight-
ened only. Push one end of 3/8" blue tubing into 3/8" connec-
tion.
7. Insert tubing and faucet assembly down through the sink
hole.
8. Position the faucet to the desired handle orientation. Slip
the slotted washer (1) between the white plastic spacer and
the sink. Securely hand tighten the mounting nut.
9. Connect the white 3/8” tubing to the drain saddle assembly
using the drain connector nut supplied. This tubing should
follow as direct a path as possible; long runs, looping or deep
sags will restrict normal brine flow to the drain. Save the
unused portion of the tubing for the installation of the storage
tank.
10. Apply a small amount of silicone-based lubricant to the
O-rings located at the base of the spout. Firmly insert spout
assembly into
the top hole of faucet body (approximately
1/4"). You may swivel the faucet left or right.
Push Handle Airgap Faucet
Airgap to system drain
(1/4" yellow tubing)
Faucet to drain saddle
(3/8" white tubing)
Product water
(1/4" blue tubing)
Metal base plate
Rubber seal
1
2
3
4
5
