OK
where x is either 0 for disabled or 1 for enabled.
4.12 Verify Auto-Attach
Depending on your settings, the Skywire may not automatically try to register on the
network. To enable this functionality, type the following command:
AT^AUTOATT=1
followed by the Enter Key, and the terminal should respond with:
OK
This command is saved in non-volatile memory (NVM), and therefore only needs to be
issued once. However, if you would like to verify that this command is set, you can type
the following command:
AT^AUTOATT?
followed by the Enter Key, and the terminal should respond with:
^AUTOATT: x
OK
where
x
is either 0 for disabled or 1 for enabled.
PN 30192 rev 10
© NimbeLink Corp. 2018. All rights reserved.
18
