Nilfisk-ALTO NEPTUNE 3, Оригинальное руководство пользователя, Страница: 7 / 22

7
1)
Options / model variants
Original instructions
NEPTUNE 3
2.2 Operating elements 1 Spray lance
2 Spray lance storage
3 Control
panel
4 Pressure gauge
5 Tank fi ller for fuel
6 Receptacle for service
crane and lifting ring
1)
7 Top cover release
8 Crank handle for
High pressure hose
reel
(Neptune..X)
9 High pressure hose
connection for machines
without hose reel
10 Main switch with
temperature controller
11 Detergent metering knob 1)
12 Power ON
13 Pump oil low
1)
14 Service interval due/expired
15 Alto AntiStone low
1)
16 Fuel low
1)
17 Castor with parking brake
18 Supply water connection
19 Tank fi ller for anti-freeze
20 Tank fi ller for Alto AntiStone
21 Canister for detergent
22 High pressure hose
reel
(Neptune..X)
23 Cable hook
24 Grip for top cover
3 Before starting the cleaner
3.1 Setting up the cleaner
Every fuel-burning appliance,
such as pressure washers,
depends upon a proper mix
of fuel and air (by weight) for
proper combustion. Therefore
some adjustment of the air
regulation to the burner may
be necessary to take account
of altitude and the resulting air
pressure. This is true whether
your fuel is ‘Natural gas’, Pro-
pane or Diesel.
Your Alto hot water pressure
washer was thoroughly tested and adjusted for optimum per-
formance before it left our fac-
tory. The factory is located at
approximately 500m (1600 ft)
above sea level, and the com-
bustion settings are optimal for
that elevation.
If your location is higher than
1200m (3900 ft) above sea
level, your burner may require
re-adjustment for proper per-
formance and best fuel econ-
omy. Contact your Dealer or
Alto for assistance.
3.2 Set the brake
1. Before using the cleaner for
the first time, check it care-
fully to detect any faults or
damage.
2. Run the machine only when
it is in perfect condition.
3. Set the brake.
See page 2 of these operating
instructions.