Nilfisk-ALTO CIP10/14, Инструкция по применению

Страница: 11 / 26

Vers. 2.1
- 22.04.08
5
3. Start-Up Procedures
Automatic Cleaning
a)
Set a scale value of approx. "4" on the dosing valve for detergents (6
and 7 on page 4). The value set is in no way related to the percentage of
detergent sucked up during operation. Dependent on the type of
detergent, final adjustment of the valve must be made during operation.
b)
Start the automatic plant from the control unit by means of the entered
program.
c)
Adjust the air pressure at 5 bar on the reducing valve for air (13 on page
4). Check the air pressure on the pressure gauge for air (13 on page 4).
NOTE!
When adjusting the reducing valve for air, carefully pull up the knob and
turn it right for pressure increase and left for pressure decrease.
d)
The foam quality is perfect when the foam is moist and small bubbles
are created. If the consistency is too thin, the foam will slide off quickly.
As a result, the time of action will be insufficient and detergents will not
be utilised optimally.
e)
Insufficient foam quality is caused by
- too low concentration of detergent
- too high temperature of inlet water
- insufficient air quantity and/or pressure
- unsuitable detergent
Manual Cleaning
CAUTION!
a) Ensure that the spray gun/outlet valve is closed.
b)
Set a scale value of approx. “4” on the dosing valve for detergents (8 on
page 4). The value set is in no way related to the percentage of detergent
sucked up during operation. Dependent on the type of detergent, final
adjustment of the valve must be made during operation.
c)
Adjust the air pressure to 5 bar on the reducing valve for air (14 on page
4). Check the air pressure on the pressure gauge for air (14 on page 4).
NOTE!