Nilfisk-Advance SR 1100 P/B, Руководство по обслуживанию

Страница: 30 / 120

SERVICE MANUAL
FLAP
GB
92 S30N1100(1)2002-01
FLAP
FLAP HEIGHT AND OPERATION CHECK (AND ADJUSTMENT)
Side flap
1. Drive the machine on a level ground.
2. Turn the ignition key (10) to OFF position and activate the parking brake (17).
3. Remove the screw (51) and the knob (50) and open the related doors (40 and 39).
4. Check the side flap (A) integrity.
Replace the flaps (see figure 2) when they have cuts (B) larger than 20 mm or cracks (C) larger than 10 mm
(see the Flap replacement paragraph).
5. Check that side flap (A) height from ground is within 0 – 3 mm (see figure 3).
After loosening the screws (D), if necessary, adjust the flap position. Then tighten the screws (D).
Front and rear flap
6. Remove the main brush, as described in the related paragraph.
7. Check the front (E) and rear (F) flap integrity.
Replace the flaps (see figure 2) when they have cuts (B) larger than 20 mm or cracks (C) larger than 10 mm
(see the Flap replacement paragraph).
8. Check that the front (E) and rear (F) flaps rub lightly on the floor but are not completely lifted from the ground
(see figure 4).
After loosening the screws (D), if necessary, adjust the flap position. Then tighten the screws (D).
9. Press the front flap lifting pedal (14) completely and check that the front flap lifts 5 cm approximately.
Release the pedal and check that the flap returns to the initial position and not in an intermediate position. If
necessary, adjust the flap lifting cable (H) by means of the register (I), located on the front side of the flap (if
necessary refer to the Flap control cable replacement paragraph).
10. Carry out step 1., 2., 3., and 6., in the reverse order.
Figura 1
S300101
Figure 2
S300102
Figure 3
S300103
Figure 4
S300104
Figure 5
S300105
Figure 6
S300106