Nilfisk-Advance SH SOLAR G, Инструкция по эксплуатации, Страница: 16 / 34

16 Original Instructions
SH SOLAR G, GH, GW
Always hold the spray lance
with both hands! 4.2.2 Automatic start/stop
4.2.3 Running with hot water The machine is equipped with a
gas burner and a boiler to heat
the water.
The heating source can be
switched on or o
ff at con-
venience by pushing the yellow
“Heating” push button (5).
Pushing the button once will
turn on the lamp in the but-
ton and switch ON the heating
source.
Pushing the button again will
turn out the lamp in the button
and switch OFF the heating
source.
On the G-model the tempera-
ture can be adjusted within the
limits stated on the “Thermo-
stat” (8), by turning the knob
to the desired value. When the
heating source is ON (push but-
ton (5) alight), the preset and
the actual outlet temperature of
the water can be read on the
display. The control unit of the
machine will monitor the water
temperature and regulate the
heating source to provide the
preset temperature.
On GH-models, with heating
tanks on the suction side of the
high pressure pump, heating
will be performed indepen-
dently of the spraying operation
- “Working mode” as well as
“Standby mode”. The tempera-
ture is controlled by a tempera-
ture sensor in the water tank.
Thus the water will always be
preheated to the desired value
– ready for use when the spray
handle is activated.
On G- models heating is per-
formed by a burner in a pres-
surized boiler. Heating is
controlled by a thermostat on
the outlet of the boiler when wa-
ter is
fl owing out of the machine
– “Working mode”. As the hot
water does not have to pass
through the high pressure pump
the maximum temperature can
be as high as 99°C.
If an error occurs to the heating
system of all models, the ma-
chine stops and the red “STOP”
push button (4) will start
fl ash-
ing and the heating source
will be shut o
ff . Press the red
button to re-set the machine.
The machine will continue to
be functional with non heated
water by pushing the green
“START” push button (3).
In this case please refer to sec-
tion "
7 Troubleshooting ".
8
3
4
5
ESC
+
-
OK
SET TEMP.
70 C
CURRENT TEMP
40 C
The machine is automatically
started when the trigger (1) of
the spray handle is activated
and will automatically stop and
enter standby mode when the
trigger is released. If the handle
has not been activated within
20 seconds, the machine will
enter stand-by mode.
When the machine is not in
use, the trigger should be lo-
cked with locking device.