ENGLISH
INSTRUCTIONS FOR USE
14
SC250, Scrubtec 334 - 9100001614
07/2016
SQUEEGEE BAR CLEANING
CAUTION!
It is advisable to wear protective gloves when
cleaning the squeegee bars because there can be
sharp debris.
NOTE
The squeegee bars must be clean and the blades
must be in good conditions in order to get a good
drying.
CAUTION!
The squeegee bars are fastened to the machine
with a snap system and can be easily removed.
1. Ensure that the machine is off.
2.
Remove the tanks container (13) from the machine body
using the handle (15).
3. Lift the machine body to access the lower part of the
cleaning deck (16).
4. Remove the squeegee bars (20) by pulling outwards.
5. Clean and wash the squeegee bars. In particular, clean the
compartments (A, Fig. 9) and the vacuum hole (B). Check
the blades for integrity, cuts and tears; if necessary replace
the squeegee bars.
6. Before installing the squeegee bars, clean the recovery
water duct (G, Fig. 10) thoroughly.
7.
Install the squeegee bars (20) and make sure they are
properly engaged.
A
A
B
B
Figure 9
P100940
BRUSH AND BRUSH COMPARTMENT
CLEANING
1.
Turn the lever (A, Fig. 10) counter-clockwise and remove
the brush.
2. Clean and wash the cylindrical brush (18) with water and
detergent.
3.
Check the brush bristles for integrity and wear; if
necessary, replace the brush.
4. Carefully clean the brush compartment (B).
5. Remove the debris collection tray (C), clean it and rinse it
with clean water, then put it back in its seat.
6. Disassemble the solution dispensers (D) and clean them
with water and detergent, then rinse and reassemble in the
relevant housings.
7. Reinstall the cylindrical brush (18) on the drive hub (E) and
engage it by turning the lever (F) clockwise.
A
F
C
B
D
D
G
G
E
Figure 10
P100941
Содержание SC250
Страница 67: ......
Страница 68: ...Nilfisk A S DK 2605 Broenby Banemarksvej 58 DENMARK www nilfisk com ...