Nilfisk-Advance City Ranger 3500, Руководство оператора

Страница: 56 / 68

56
4
3
Service and maintenance
Operator’s Manual City Ranger 3500
3.12 Changing a wheel
Attention!
Operate on level and stable ground. The
engine must be stopped and the parking
brake activated.
To carry out this operation, you require a jack able to
support two tonnes and a spare wheel with a new tyre.
1. Chock the wheel opposite to the wheel to be lifted.
2. Place the jack under the axle closest to the wheel to be
changed, in contact with the axle body (point opposite to
the arrow). (Pictures 1+ 2)
3. Once the jack is well positioned, loosen the wheel bolts.
4. Raise the jack until the wheel is e few centimeters above
the ground. Watch out the vehicle’s stability when raising.
5. Unscrew and change the wheel. Screw the bolts but do
not tighten.
7. Lower the jack and then tighten the wheel bolts to
torque 120 Nm.
After 20 hours of use, tighten the wheel bolts.
!
Jack position at the rear
Jack position at the front