12
- FORM NO. 56041387 / Carpetwin
™
16XP, 20XP
revised 1/00
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
CHANGING THE BRUSH / BELT
By turning the Brush Height Adjustment Knob, you can compensate for some normal brush wear. Rotating the Bearing
Blocks allows you even more compensation. Change the brush when the brush bristles are worn to 1/4 inch (6 mm).
To
Rotate the Bearing Blocks or Change the Brush:
1
Remove the bottom cover from the brush housing.
2
Remove the Shoe from the brush bousing.
3
Look to the number visible on the bearing blocks. If the number showing is
2
, you can rotate the bearing blocks to
number
1
and still have some brush wear left. Replace the brush if the number visible is
1
.
4
Stretch the Belt as you pull the Brush out of the Base.
5
Inspect the Belt and Motor Pulley, replace if neccessary.
6
Rotate the Bearing Blocks so that number
1
is visible and install the Brush with the Belt. Or, install a new brush with
the Belt so that number
2
is visible on the Bearing Blocks.
7
Install the Shoe and the bottom cover.
MAINTENANCE
Motor
Pulley
Belt
Bearing Block
With Number 2
Visible
Shoe
Changing the Brush or Rotating the Bearing Blocks