Nilfisk-Advance 56514850, Инструкция по эксплуатации

Страница: 29 / 76

GENERAL MACHINE MAINTENANCE
ENGINE
Read and follow all the instructions in the Engine Manual Section. Due to the nature of work being done by the machine, extra care must be taken
to protect the engine from these elements. Check the oil each day before starting operations. Be sure to check the air
fi lter cap’s dust collector and
empty as necessary. Also check the air cleaner and replace as conditions demand. Do not let the engine become coated with dust and dirt.
FIGURE 24
TO REMOVE MAIN SWEEPING BROOM
1. Open the Right Broom Chamber Door (A) .
2. Put the main broom control in the “SWEEP” position.
3. Remove the Retaining Bolt
(B) .
4. Remove the Idler Arm Assembly (C) .
5. Remove the Main Broom (D) and discard.
6. Put a new main broom in the broom chamber.
7. Rotate the new broom to the right on the Drive Hub
(E) until it engages the drive hub broom tabs.
8. Put the Idler Arm Assembly (C) in place.
9. Put the Retaining Bolt (B) in place and tighten.
10. Close the Broom Chamber Door (A) .
11. Start the engine.
12. Put the broom lever in the “SWEEP” position.
13. Let the broom sweep in place for 30 seconds.
14. Put the broom lever in the “UP” position.
15. Back the machine off the test spot.
16. Inspect the polished area where the broom swept, for broom bristle contact with the
fl oor. The area of broom bristle contact with the fl oor
should be 2 to 3 inches (5 to 8 cm.) wide.
E
D
C
B
A
ENGLISH / A-29
FORM NO. - 56041719 - CR 1500 - A-29