©
2014 Nil
fi
sk-Advance, Inc.
3/06 revised 8/14 Form No. 56040888 REV C
page 6 of 6
7
See Figure 5.
Connect the BLK Cable
(A)
to the Electrical Mount
(B)
on the right. Connect the RED Cable
(C)
to the Electrical Mount
(D)
in the
middle.
8
In the general area of the Speed Controller
(E)
you will
fi
nd a single violet wire connected to (3) violet wires via terminal tab connectors. Pull
these connectors apart.
9
Connect the single White Wire
(F)
from the battery charger to the (3) violet wires disconnected in step 8. Connect the single Black Wire
(G)
from
the battery charger to the single violet wire disconnected in step 8.
NOTE:
The white and black wires are one of the (3) wires referenced in step
6 routed inside a single conduit
(H)
.
IMPORTANT!
Verify that no charger wires are pinched or routed through small diameter turns, that there is no potential for rubbing against any sharp
edges, and that wires do not hang down where they may be susceptible to damage.
10
Tie
Strap
(1)
the (3) wires from the battery charger to the existing wiring harness bundle which is also routed up through the same opening in the
body.
11
Reinstall the front Panel
(B)
removed in step 5.
OPERATIONAL NOTE:
Before charging the batteries, open the battery compartment cover to allow proper ventilation. If you use one of these
battery chargers as a shelf unit the charger has to be unplugged from the wall between charging sessions otherwise it will not start a second charging
session.
FIGURE 5