©
2014 Nil
fi
sk-Advance, Inc.
3/06 revised 8/14 Form No. 56040888 REV C
page 2 of 6
INSTALLATION INSTRUCTIONS
WARNING!
DISCONNECT BATTERIES BEFORE SERVICING.
1
Check the setting of the dip switches on your charger. See the chart below for the proper setting. Note: Only if you are using the charger with
AGM batteries will you need to move the position of the switches to match that shown below for AGM batteries. If you are not using AGM
batteries leave the switches in their default positions.
FIGURE 1
Charger set to
default
charging curve 1 for flooded batteries.
No changes to charging curve required.
Set charging curve to 14 for
Discover AGM
batteries.
Dip switches are accessible by lifting up the left
corner of display panel of the charger.
2
See Figure 1.
Install the Battery Charger
(6)
on the rear panel of the chassis as shown using hardware Items
(2, 3 & 4)
.