●
Near other wall controls (see caution below)
DO NOT INSTALL THE AB-2D INTO ELECTRICAL BOXES
WITH 110 VOLT DEVICES.
Some states or municipalities allow devices such as the AB-2D
to be installed into the same electrical box as 110 volt
devices, provided a "low-voltage partition" is used between
the devices. We do not recommend this. Speaker wires can
act as an "antenna" for electrical noise. Locating speaker wires
too close to a light switch or dimmer may cause a "popping"
or "buzzing" sound to be heard through the speakers. If you
must locate the AB-2D near electrical devices, install it in a
separate metal electrical box, ground the box to the electri-
cal system ground, and route the speaker wires several feet
away from the electrical wiring.
Changing the Color of the AB-2D
The Decora insert and buttons on the AB-2D are removable,
allowing fast and easy color changes as needed. Inserts and
buttons are available in a variety of colors.
If you need to change the color of the AB-2D:
1.
Obtain the AB-2D Decora inser t and buttons in the
desired color from your Niles dealer.
2.
Holding the AB-2D as shown in
(Figure 1)
, locate the two
plastic mounting tabs at the top rear of the Decora insert.
Using two fingers, simultaneously press both tabs down
(towards the center of the insert) and forward (away from
5
S
S
P
P E
E A
A K
K E
E R
R
// A
A
M
M P
P L
L II F
F II E
E R
R
S
S
E
E L
L E
E C
C T
T O
O R
R
