Nikon XT V 160, Руководство оператора

Страница: 11 / 94

XT V 160 X-ray System
XTM0011-F2
1
1 Important health and safety information
1.1 Safety notice
It is extremely important to read ALL safety information and instructions and any
accompanying documentation before operating the system. The Operator Safety Manual is
an integral part of the product and must be kept with the X-ray system at all times.
Observe all cautions and warnings during routine use of the system. All operators must have
read and understood the Safety Information and the X-ray system's Operating Instructions
and have received relevant training before using the X-ray system for X-ray inspection. Any
operator performing Routine Maintenance Tasks as detailed in the X-ray system's Operator
Manual must have received appropriate training in these procedures.
Before opening the operator door (or any other access panels), you
must switch X-rays off from the X-ray zone of Inspect-X.
Do not attempt to unpack, install or commission the system.
Unpacking and installation must only be performed by a qualified
Nikon Metrology service engineer.
Do not move the system. Contact a Nikon Metrology representative if
you wish to relocate the X-ray system.
The X-ray system is designed to operate under the following environmental conditions:
•
External temperature range to be 10°C to 30°C.
•
Relative humidity to be 30-80%, dew point <14°C.
•
Vibration to be less than -3 µm/s RMS (ISO VC-B).
•
Air cleanliness must be ISO 8 (ISO 14644-1) and Pollution Degree 2 or better.
•
The system is IP20 rated and not designed to be used in a wet environment.
The system should be sited on flat, suitably rated ground, with sufficient clearance left for
service access. Refer to the relevant installation drawing for your system for further details.
Fusing requirements
Supply voltage/tap (V) Recommended fuse/breaker capacity (A)
100 16
110 15
115 15
200 10
220 10
230 8
240 8