99
Troubleshooting
LCD panel
Viewfinder
ƒEE
blinks
ƒEE
blinks
M
appears
—
M
blinks
—
M
and
Err
Err
blinks
blink
ƒ--
appears
ƒ--
appears
Err
and
E
blink
Err
and
E
blink
a
,
s
, and
Err
blinks
Err
blink
E
blinks when
E
blinks when
exposure meter
exposure meter
is turned on
is turned on
End
blinks
End
blinks
—
?
blinks
Cause
• CPU Nikkor lens (other
than G-type) is not set
to its minimum
aperture.
• Batteries are nearing
exhaustion.
• Batteries are just about
exhausted.
• Batteries are
exhausted during film
rewind.
• Non-CPU lens is
attached or lens is not
attached.
• Film is not correctly
advanced.
• Film speed is set to DX
and non-DX-coded film
is loaded.
• Film remains in the
camera after film
rewind is complete.
• The end of the film roll
has been reached.
• Autofocus is not
possible.
Page
18
17
17
17
18, 32
21
21, 34
29
29
27
Remedy
• Set lens to minimum
aperture.
• Have fresh ones ready.
• Turn the power off and
replace batteries with
new ones.
• Replace batteries with
new ones or recharge
batteries and turn the
power on again. If this
warning appears
frequently, contact
authorized Nikon dealer
or service center.
• Attach CPU lens (except
IX/DX-Nikkor). With a
non-CPU lens, set the
exposure mode to A or
M and set the aperture
with lens’ aperture ring.
• Reload film.
• Load DX-coded film or
set the film speed
manually.
• Remove the film
cartridge.
• Rewind film by
pressing the two film
rewind buttons
„
.
• Focus manually.
Miscellaneous
F100_En_16 7/8/05 8:06 PM Page 99
Содержание F 100
Страница 1: ...En INSTRUCTION MANUAL En ...
Страница 14: ...14 ...