Page - 6 -
PSS 25 - 0304
Free standing tracks and track joints are to be separated by at least a full
section. See 4.6 assembly regulations.
At assembly of curves, a load-bearing coupling is to be put in the middle of each
curve. Instruction for the exact positioning of the coupling is at 4.1.1, which is to be
followed. In the case of tracks, which are slanting - suitable supporting devices must
be assembled so that the reel runs over no brake mechanisms. This can only take
place with further discussion with the manufacturer, or more specifically after a
calculation by a control body.
(All non-horizontal tracks must need a special examination)
The switches are screwed into the system with connecting coupling and are to be hung
immediately before the connecting coupling. Track stoppers are to be used on open
tracks, which must be secured against shifting horizontally with a steel screw DIN
933 M8x80.
