Use a drill (with a 6 mm diameter) to drill a hole of 40 mm for each connector. If you are drilling in wood, you will not need
to use the connectors, and only a drill hole of 20 mm with a 3 mm diameter will be required.
Follow the steps below to mount the touchscreen:
1
Screw the mounting plate onto the wall using the four screws and connectors supplied.
• Mount the mounting plate in a central position on top of the flush-mounting box.
• Make sure the mounting plate is level.
• The unevenness of walls cannot exceed 2 mm.
2
Connect the green screw connector supplied to the 24V power supply cable while observing the polarity as indicated
on the back of the touchscreen.
• If you are using a PoE power supply, you do not need a separate 24V power supply cable.
• Only use the Niko PoE power supply type IEEE802.3af. This power supply provides voltage via the free pairs.
• The green screw connector supplied (24V power supply) is suitable for a maximum copper diameter of 1.5
mm².
3
Mount a RJ45 connector on the twisted pair cable (UTP, STP or FTP) according to T568B.
Min.
1,50m
Touchscreen
45
