
28
10-801 /10-802
step 4:
ending programming status
Briefly press
The LED lightens steadily.
the “mode” button
note:
The parallel programming of multiple internal units (max. 2 on the power supply
module or more with the service unit) will increase the power consumption. The
numbers given in table 1 will then NO LONGER apply.
remark:
If you do not have access to the premises, and thus cannot pick up the receiver of
the internal unit, you can carry out the programming via the service unit (reference:
10-870, see manual). If a bell push-button is present at the front door, you can
also carry out the programming as follows:
step 1:
entering system programming status
The LED is on.
Briefly press
The LED blinks.
the “mode” button
step 2:
linking the bell push-button to the correct internal unit
Press the bell push-button at the door, release it and press it
again (within 3s
step 3:
programming a bell push-button
Briefly press the relevant bell push-button at the front door. You hear a
ringing signal both on the internal and external unit in confirmation of
the programming.
EN
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
1
1
3
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
1
1
3
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
1
1
3
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17
1
1
3
12V 1A max
12V 1A max
12V 1A max
1
2
6s