Sometimes, it may be difficult or even impossible to orient the transmitter unit
such that it can be "seen" (means face-to-face) by theA/V equipment you wish
to control. Perhaps there is no good surface that allows for this or perhaps you
wish to control. Or perhaps you wish to remotely control A/V equipment in
different locations without re-orienting the transmitter. So, in this case, to use
in extender will be more convenient.
In order to obtain optimum performance of the remote control extender,
please operate as follow:
At the transmitter
：
Put IR Header near opposite to AV source IR receiver,
and keep remote antenna (outlet of A/V cable), in loose state with its end away
from cable.
At the receiver:
Direct remote control straightly against IR receiver in a distance of 5
meter, and keep remote antenna (outlet of A/V cable), in loose state with its
end away from cable.
DVD/VCR/SAT
Infrared receiver
15
G. Troubleshooting, Care and maintenance
Please read this owner's manual carefully and follow the steps described in it. If
you still have difficulties, consult the following table. It will guide you though
the most common problems and their solutions.
Problem
Possible solutions
No picture or sound
•
Check all cable connections.
•
Make sure power plugs are pushed all the way in.
•
Check power switches on the remote TV and
Video source. (VCR, laser disc player, satellite
receiver, ect. )
•
Check the power on/off switches on the
transmitter and receiver.
Interference:
Noisy picture or audio
•
Adjust receiver and transmitter antenna
orientation. ( see section on "Orienting Units for
Optimum Performance" in this manual )
•
Select a different channel by pushing the channel
selector button on both transmitter and receiver
so that the channels match.
•
If using a microwave oven, turn it off.
•
Remove microwave oven from path between
transmitter and receiver.
Remote control
extender does not
work
•
Check the path between the transmitter and the
audio/video source and clear any obstructions.
•
Check to see if the IR window on the bottom
front of the transmitter is blocked.
•
Make sure IR extender is properly rotated in the
A/V equipment you wish to control.
•
Adjust remote control antennas. (see section on
" Using the Remote Control Feature " in this
manual )
Note:
Clean the outside plastic packaging with a soft cloth lightly moistened
with mild soap and water. Never use any abrasive scouring powder
or solvent.
16
